This stylish quilted toilet roll holder can be made in the 5x7 or 6x10 size hoop. This is an ITH (in the hoop) machine embroidery design.
There are three different quilted blocks included in the holder.
The 5x7 size panels will better suit toilet rolls that are approximately 12 cm (4½”) wide by 12 cm (4½”) high or smaller. The 6x10 size panels can suit toilet rolls that are a bit larger. Our sample only has two toilet roll spaces, however adding more panels to the holder will allow for more spaces.
The blocks are each made in the hoop and then joined together with a regular sewing machine. There is also a small amount of hand stitching required to seal the final opening where the project is turned right side out (~3-4"), you could also use fabric glue to seal this opening.
Final Dimensions (approx.) of holder with two toilet roll spaces:
5x7 -12cmW x 42cmL (4 ¾” x 16 ½”)
6x10-15cmW x 42cmL x (5 ¾” x 16 ½”)
Full photo instructions and directions are included with your purchase.
It is our intention to offer you the best service always and for our designs to be of the highest quality.
Designs are provided in 9 different embroidery formats. The formats included are: DST, EXP*, HUS, JEF, PEC, PES, VIP, VP3 and XXX.
*BMP and INF files are also provided, these are recommended to be used with the EXP files for Bernina machines.
SVG files are included for cutting machines. Please note the SVG format can be converted to FCM within the Brother Scan n Cut software if required.
We test and review each of our designs to ensure the highest quality. Depending on what hoop, fabric and stabiliser combination you are using, results may differ.
